Discussion in 'International Area' started by ex-egll, Nov 26, 2008.

  1. ex-egll

    ex-egll New Member

    Hi all, just started using the software with an Icharger 106B+. My German is almost non-existent:eek: so what I am about to ask may well be covered in the manual.

    Is it possible to "lock" the values of certain parameters on the Y axis, specifically I would like to either fix or have the Y axis for individual cells the same. This would make it easier to track voltage differences between cells just by looking at the graph.

    Off to learn more German,

    ex-egll
  2. ducati24h

    ducati24h New Member

    Sure, there are several method, one of them is:
    Graphic > End Value Wizard
    Then select signal , Chose Max, Chose Min and click “ubernehmen”

    Then Graphic > save graphicaft
  3. Dominik

    Dominik Administrator Staff Member

    Hi !

    And don´t forget to switch to english ....

    Attached Files:

  4. ex-egll

    ex-egll New Member

    Thanks, I knew there had to be a way to do it,

    English selected!:)
  5. Hawks1200

    Hawks1200 New Member

    Is there a way to change the names of the lines on the graphs to english as well?
  6. Dominik

    Dominik Administrator Staff Member

    Hi !

    This is possible.

    Just move to the folder ...
    C:\Documents and Settings\Dominik\Application Data\LogView\Geraete
    (that´s the german path)
    c:\documents and settings\<user>\application data\LogView\Geraete
    (That´s the english path)

    Search your device and open the INI file. Scroll down and change the strings for "MessgrößeXX". That´s all.

    Keep in mind to make a backup of your changed file. If LogView get´s an update it will detect an change to that file and replace it with the original !
  7. Hawks1200

    Hawks1200 New Member

    Thank you, I found the file, and made the changes. But they did not show up on the main graphic tab:

    see pic 1

    They did show in other tabs such as the Analogview tab:

    see pic 2

    It is possible that I missed somthing, thank you for your help.

    ADMIN:
    Please attache pictures to your posting. It can be done with "Anhänge verwalten".

    Attached Files:

  8. Dominik

    Dominik Administrator Staff Member

    Hi !

    I think you saved a graphic template. This template also includes the axis names.

    Please go to:
    c:\documents and settings\<user>\application data\LogView\Templates Grafik
    Search your device and delete the .lvt corresponding file.

    Restart LogView ....
  9. Hawks1200

    Hawks1200 New Member

    Excellent. That is exactly what was needed. Thank you very much, and maybe I can pass this information along to others that would like it.
  10. Dominik

    Dominik Administrator Staff Member

Share This Page